Onkyo TX-RZ3100 User Manual page 18

– When two sets of height speakers are being used
– When "Zone Speaker" is set to "Zone 2/Zone 3"
– When height speakers and ZONE speakers are being used at the
same time.
2. Crossover
If you are using THX­certified speakers, we recommend the following settings:
– Set a value "80Hz(THX)" in Crossover frequency.
– Set a value "80Hz" in "LPF of LFE".
– Set a value "Off" in "Double Bass".
Front
Default Value: 80Hz (THX)
Select the crossover frequency from "40Hz" to "200Hz" to start outputting
frequencies for each channel.
"Full Band": Full band will be output.
If "Configuration" ­ "Subwoofer" is set to "No", "Front" will be fixed to "Full
Band" and the low pitched range of the other channels will be output from
the front speakers. Refer to the instruction manual of your speakers to
make the setting.
Center
Default Value: 80Hz (THX)
Select the crossover frequency from "40Hz" to "200Hz" to start outputting
frequencies for each channel.
"Full Band": Full band will be output.
"Full Band" can be selected only when "Front" is set to "Full Band".
If an item cannot be selected even though connection is correct, check
that the settings in "Configuration" ­ "Speaker Channels" matches the
number of connected channels.
Height 1
Default Value: 80Hz (THX)
Select the crossover frequency from "40Hz" to "200Hz" to start outputting
frequencies for each channel.
"Full Band": Full band will be output.
"Full Band" can be selected only when "Front" is set to "Full Band".
If an item cannot be selected even though connection is correct, check
that the settings in "Configuration" ­ "Speaker Channels" matches the
number of connected channels.
Height 2
Default Value: 80Hz (THX)
Select the crossover frequency from "40Hz" to "200Hz" to start outputting
frequencies for each channel.
"Full Band": Full band will be output.