Assembly Instructions - New Construction - Delta ITG70BT Instructions Manual

ASSEMBLY INSTRUCTIONS
NEW CONSTRUCTION
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
1. Attach the duct connector
housing .
1
2. Remove the wiring box cover from the fan
housing . Remove the wiring knockout from
1
the wiring box cover with a flathead screwdriver
(not included).
3. Place the fan housing
or wall stud, The fan housing
and perpendicular to the joist or stud.
4. Mount the fan housing
using nails (not included) where indicated.
5. Pull the wire through the hole and into the junction
box (not included), secure 120VAC house wiring
from the wall switch to the fan as shown in the
wiring diagram on page5. 14AWG is the smallest
conductor that shall be used for branch-circuit
wiring.
Push the wires back through the hole.
Reattach the wiring box cover.
Model: ITG70BT
to the fan
3
next to a ceiling joist
1
should be level
1
1 to the joist or stud
1
1
2
3
1
4
Joist or wall stud
5
6
3
1
Joist or wall stud
1