Duct Connector - Delta ITG70BT Instructions Manual

ASSEMBLY INSTRUCTIONS
3. If this fan is not replacing an old fan, be sure to cut
a 7 in. x 7 in. opening for the fan housing
1/2 1/4
Make sure the 7 inch side of opening is flush with
1/4
the joist for installation from below.
4. Attach the duct connector
5. Remove the three screws that hold the fan motor
assembly in place. Remove the fan motor assembly
from the fan housing
connector.
6. Pull the wire through the hole and into the junction box
(not included), secure 120VAC house wiring from the
wall switch to the fan as shown in the wiring diagram
on page5. 14AWG is the smallest conductor that shall
be used for branch-circuit wiring.
Push the wires back through the hole. Reattach the
wiring box cover.
7. Install a circular 4 in. duct (not included) and secure
it with duct tape or clamps (neither included).
8. Insert the fan housing
in the ceiling. The fan housing
and perpendicular to the joist or stud.
Model: ITG70BT
to the fan housing
3
. Unplug fan and speaker
1
through the existing hole
1
should be level
1
3
.
1
4
.
1
1
5
1
6
7
8
1
8
3
FAN CONNECTOR
SPEAKER CONNECTOR
a