Assembly Instructions - Existing Construction; Grille - Delta ITG70BT Instructions Manual

ASSEMBLY INSTRUCTIONS
6. Install a circular 4 in. duct (not included) and
secure it with duct tape or clamps
(neither included).
Finish ceiling work. The ceiling hole should be
aligned with the edge of the fan housing.
7. Plug the Micro USB connector into the speaker
assembly , and secure the speaker assembly
4
to the holder on the fan unit.
8. Pinch the mounting springs on the grille
and insert them into the narrow rectangular slots
inside the fan. Push the grille up toward the
ceiling.
Turn on electricity at the breaker box after
finishing installation.
EXISTING CONSTRUCTION
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
1. Remove existing fan.
2. Measure the opening to ensure it is large enough
to accommodate the new fan body
(7 in. x 7 in.).
1/2 1/4
Note: 7 inch side of opening should be flush with
1/4
the joist.
6
7
,
2
8
1
2
7
4 in. duct
Duct tape
or clamp
4
2
Ceiling
Model: ITG70BT