Sony BVP-570 Maintenance Manual page 620

5-1. Preparation
5-1-6. Initial Setting
Internal Switches:
n
When switching the following switches from a customer-
set position, it is recommended to record the setting state
of the customer in the table below.
After adjustment is complete, be sure to return the switches
to their customer-set positions.
Board Switch Initial setting Customer-set position
AT-126 S1-1 ON
S1-2 OFF
S1-3 ON
S1-4 OFF
Setup Menu:
n
Be sure to recall the standard file before making the
following settings by the setup menu.
MENU : Paint
PAGE : Scene File (P8)
ITEM : Standard
(Press the MENU SEL switch to execute.)
. MENU:
Operation
Page Item
Gain Sw (?3) Low
Middle
High
Wide Screen (?4) *1 16:9/4:3 Mode
*1 : This setting shall be done only when the OHB-455WS/455WSP/
T450WS/T450WSP/550WS/550WSP or BVP-570WSPK is used.
. MENU:
Paint
Page Item
Video Level (P1) Test
Detail 1 (P2) Dtl
Skin Detail 1 (P4) Master SW
Gamma (P5) Gamma
W.Clip/Knee (P6) W.Clip.
Knee
Matrix (P7) Matrix
5-6 (E)
n
Be sure to execute the reference file store after making the
above settings by the setup menu.
MENU
PAGE
ITEM
(Press the MENU SEL switch twice to execute.)
On the Side Panel :
VTR SAVE/STBY switch → STBY
GAIN switch → L (0 dB)
OUTPUT/DCC switch → CAM/OFF
WHITE BAL switch → PRST
On the Front Panel :
SHUTTER switch → OFF
Filter Setting : 3200 K
OHB-550/550WS/455WS series → 1B (FILTER selector)
BVP-570WSPK → 1B (FILTER selector)
OHB-450/451/T450WS series → 1 (FILTER selector)
5-1-7. How to Output Camera Color-Bar
Initial setting
When performing adjustments using the camera color-bar
signal, there are two approaches to outputting the signal.
0 dB
9 dB
However, when the unit is used with the MSU-700, use the
18 dB
setup menu to output the camera color-bar signal because
16:9
the OUTPUT/DCC switch on the side panel is deactivated.
n
When the unit is used with the MSU-700, the BARS button
of the MSU-700 can not used to output the camera color-
bar signal, too.
Initial setting
. OUTPUT/DCC switch (Side panel) → BARS
Off
On
or
. System config menu
Off
On
Off
Off
Off
: Trimming File
: Trimming File (T1)
: File Store
Signal
PAGE : Y/Chroma (S2)
: CB → On
ITEM
BVP-570