Advertisement
Connecting Up
The REL Arrow™ Wireless Transmitter is intended to be used with the SerieT/i or similar REL sub bass
system. The transmitter will require power from an AC wall plug using the power adapter cable supplied.
It is not possible to use the Arrow™ wireless connection and a direct connection simultaneously. Using both
wired and wireless connections simultaneously could result in damage and voids all warranties.
Always switch your system off before disconnecting any wires.
The transmitter must be mounted to the base using supplied hardware. Make sure the electrical interface
is fully engaged to ensure proper performance. Mounting screws need only be finger tight.
The receiver must be mounted to the back panel of the SerieT/i using supplied hardware. Here too, make
sure the electrical interface is fully engaged to ensure proper performance and the mounting screws need
only be finger tight.
REL Arrow™ Receiver
1 LED: Indicates whether the REL Arrow™ receiver
2 Pair Switch: Used to pair REL Arrow™ receiver
1
3 Power Switch: Used to turn on and off REL
2
4 Interface plug: Used to connect REL Arrow™
3
4
2
is paired with the transmitter or not.
with REL cabinet.
Arrow™ receiver.
receiver to SerieT/i back panel.
Advertisement
