Advertisement
REL Theater Reference™ Home Cinema Applications
For Dolby Digital AC3 or other 5.1 theater systems, once the standard set-up for two-channel outlined
above is complete, the LFE output from the processor or receiver should be connected to the .1/LFE input
and appropriate volume adjustments made using the .1/LFE LEVEL control. For this configuration, you must
set the processor to the "large" or "full range" setting for the left and right speakers in order for the REL to
receive the bass signal via the high-level cable. In this configuration, the REL provides support for both the
left and right speakers for two-channel listening, and support for the LFE when movies are playing. Most
processors will allow you to defeat the subwoofer output when listening in the two-channel mode. The
effect of this set-up is one of greatly increased dynamics in the mid-bass range, no bass bloat, and a greater
degree of space and timing from the special audio effects.
Pairing
Now that the Arrow™ Wireless Transmitter is connected to your amplifier (ideally using the High Level cable),
and the receiver is installed on the amplifier panel, the unit will need to be paired to the REL subwoofer
or subwoofers.
1 Make sure that the transmitter AC to DC wall plug supply is connected to an AC outlet, and that the barrel
connector is connected to the transmitter.
2 Turn the transmitter power switch on and a blue LED on the front of the side of the transmitter will indicate
the unit is on by blinking in the standby pattern which is one flash per second.
3 Make sure that the sub is plugged into an AC outlet using the supplied AC cable and that the sub is turned
on. Power switch is located on the rear panel.
4 At this point the transmitter and receiver should find each other and pair together. This will be indicated
by the "Pair" LEDs on both the transmitter and control panel staying lit (no flashing).
5 In the event that the transmitter and receiver do not automatically pair, simply exercise the momentary
"Pair" switches on the transmitter and the receiver simultaneously.
Standby
Status
Paired
LED Indicator
Continuously On
Blinks Once per Second
8
Advertisement
