Table of Contents
Advertisement
If
There are two methods for uploading snapshots. If you enable
continuously at configurable intervals over a configurable period. If FTP put snapshot with date and time suffix is
disabled, the video server can use FTP for uploading and overwriting the snapshot files. You configure the remote
folder for the snapshot files on the network page. The snapshot time period is from
and is repeated daily. Set the snapshot interval under
Use
administrator can choose any combination of conditions to generate special applications according to personal
requirements. The video server monitors the channel and the digital input continuously. Snapshots taken after an
event
can
be
configured
VTRG.JPG
and
same event.
Two types of
For motion detection, window names are displayed below for selection. The configuration of motion detection is
described in the previous section. After you select the
the digital output and/or uploads the snapshots according to the settings under
output to reset the original state of the alarm input/output.
to combine motion detection with the digital inputs or for sending snapshots. The
so
that
VPOS.JPG.
The
are available. Four device operation options are available for the digital input.
is disabled, the file is overwritten by the newest snapshot.
they
are
delayed
following an event. The three snapshot types are VPRE.JPG,
administrator
can
to reduce multiple start procedures caused by the
32
, snapshots are sent
according
to
the
set
the
time
, the video server operates the device at
to
.
setting
of
delay
under
. Click Reset
Advertisement
Table of Contents
