Table of Contents
Advertisement
The TV7202 uses MPEG4 Codec compression as the best streaming solution. The size of the compressed video
data is much less than with JPEG. However, this depends on the picture change between two consecutive pictures.
Three parameters are available for this setting.
to optimise bandwidth use and video quality. If the user wants to fix bandwidth usage irrespective of the video
quality,
maximum frame rate within the limited bandwidth, the video quality suffers, particularly if there are bog changes
between pictures.
Select
to mirror the video picture vertically and
Click
are displayed with a red frame. If this option is disabled, setting made for motion detection has no effect. Motion
detection increases the system load. For an extended configuration, go to the Motion detection page.
To set the best video quality, click
settings. There are four fine setting options:
11 stages (-5 to +5). To check your fine settings, click
to save your picture parameters.
your changes. If you change parameters without saving them, they are used only until the next system reboot.
Restricts the maximum frame rate, which can be combined with
to enable the motion sensor. When this option is enabled, the sensor fields
and the desired bandwidth must be selected. If you select the
horizontally.
, which opens a window where you can make fine
,
,
. If you are satisfied with the picture, click
Click this button to restore the original settings and discard
24
and
. Each field has
Advertisement
Table of Contents
