Compsee apex User Manual page 24

Apex III Dock User's Manual
AC Power Cord
Figure 3-8: AC Power Connection
9. If the Apex III Dock is to be mounted in the vertical position
(e.g. on a wall), remove the PDT Mounting Hook from within
the Apex III PDT resting area (refer to Figure 3-9).
HOOK
MOUNTING
SLOT
Figure 3-9: PDT Mounting Hook Location
And Orientation (Top View Of Dock Shown)
10. Flip the PDT Mounting Hook over and re-insert it into the
slot to prevent the Apex III PDT from sliding downward
during vertical mounting of the Dock (refer to Figure 3-9).
11. To use the Dock spare charging slot, insert an Apex III
Battery Pack into the charging slot on the top rear of the
Apex III Dock (refer to Figure 3-10, Warning, and Note).
3-4 COAM30003 Rev. 1.04
3 Dock Setup And Operation
AC Receptacle
[Correct Voltage Dependent
On Unit Ordered]
PDT
MOUNTING
HOOK
HOOK UP FOR
VERTICAL MOUNT
SIDE
END
09/03/01