Compsee apex User Manual page 23

Apex III Dock User's Manual
5. Plug the round male Power Supply DC voltage connector
(cable permanently attached to Power Supply) into the DC
voltage connector on the back of the Apex III Dock (refer to
Figure 3-6).
Power Supply
DC Voltage
Connector
Power Supply
DC Voltage
Connector
Figure 3-6: Apex III Dock (Rear View)
Note: For a detailed description of the Dock connectors refer to
the Technical Information section of this manual (p. 4-1)
6. To use the Apex III Dock for communications with the Apex
III PDT, connect the 10 pin Phone Plug of the Compsee serial
communications cable (PN 0227001) to Port 2 on the back of
the Dock (refer to Figure 3-6 and Figure 3-7).
Figure 3-7: Apex III Dock Communications Cable
(10 Pin Phone Type Connector Required)
7. Connect the RS-232 (DB-9) connector on the other end of the
communications cable to the Serial Port on an IBM based PC
or other serial device (refer to your device specific User's
Manual).
8. Plug the AC Line cord into an AC power receptacle (refer to
Figure 3-8).
COAM30003 Rev. 1.04
3 Dock Setup And Operation
Spare Battery
Pack
Charging Slot
9VDC 3. 5 A
PORT 1 PORT 2 PORT 3
Communications
Port (Port 2)
09/03/01 3-3