Fault Diagnostics - haupa AS-6 Instruction Manual

6. FAULT DIAGNOSTICS

Before performing any work on the tool, ensure that it is disconnected from the mains.
ATTENTION: If you should require any service other than those detailed below, please consult the nearest Technical
Service Centre.
PROBLEM
The tool does not move, moves
slowly or jumpily forwards
The tool does not move, only
partially or moves slowly
Oil loss at piston
Crimp process is not completed or
does not return to the basic
position
In all cases, we would advise sending the machine to the nearest Technical Service centre for repair.
Always use original spares. Any other part type could seriously damage the tool and would void the guarantee.
Phone: +49 (0)2191 8418-0, Fax: +49 (0)2191 8418-840, sales@haupa.com • Errors and technical changes reserved.
POSSIBLE CAUSE
Air in the system
Oil level low
Cylinder piston jammed
Leaks on the installed pump
Air in the system
Return spring damaged or other
damage to the cylinder
O-rings damaged
Battery is not sufficiently charged,
therefore there is not sufficient
hydraulic energy to release
Germany: HAUPA, Königstr. 165-169, 42853 Remscheid
SOLUTION
Hold the pressing head upright an press the
operating buttons for feed and the release valve
simultaneously for around 10 seconds
Fill oil in accordance with the instructions above
Check the cylinder for damages.
Contact info@haupa.com
Contact info@haupa.com
Bleed as described above
Contact info@haupa.com
Contact info@haupa.com
Insert the replacement battery. Ensure that the
replacement battery is always charged.
CAUTION: Pushing the operating button too firmly
may cause damage to the release valve.
...convincing solutions
english
11