Hoover Steam Fresh Combi User Manual page 7

• The steam mop and accessories get very hot during use, always allow them to cool down before handling.
• Always unplug and switch off the steam mop when assembling.
• Always switch off the steam mop before emptying the water tank or changing the cleaning pads/accessories.
• IMPORTANT: Please refer to floor manufacturer's care recommendations before use and test the steam mop
on a discrete area of flooring to begin with.
• When using the steam mop, basic safety precautions should always be observed.
• Don't aim the steam mop at people, animals, plants and electrical components such as interior of ovens or wires.
Never touch the steam burst or floor head from a short distance. (There is a risk of scalding)
• The steam mop is equipped with a thermostat and a thermal cut-out. If for any reason the steam mop overheats it
will switch off. If this happens turn off and unplug the steam mop, allow to cool for a least 2 to 4 hours and re-start.
Using the steam mop
Place the microfibre Plug into mains and
pad on the floor press the power
white side facing button to switch on.
up. Place steam mop The blue light will
onto pad making illuminate to show
sure the entire pad power on. The green
covers the light will illuminate
floor head to show the steam
mop is ready to use
Push On/Off switch to
turn machine on
Adjust the steam dial
to desired setting
To produce steam
squeeze the trigger in
short bursts. Don't
hold the trigger
continuously to prevent
over wetting floors
To steam your floors
with detergent turn
the dial to ON and
without detergent
turn the dial to OFF
Move the steam mop
slowly backwards and
forwards across the
floor paying particular
attention to high traffic
areas. Squeeze/release
trigger as required
OPERATION
To recline the steam
mop place foot on
floor head and pull
handle backwards
Hold corner of pad
down with foot and lift
steam mop to
peel away
6