Fujitsu PRIMERGY RX1330 M3 Operating Manual page 72

Starting up and operation
Ê Follow the on-screen instructions (see also section
server and installing the operating system with the ServerView
Installation Manager" on page 74
installing the operating system without the ServerView Installation
Manager" on page
– System already installed:
Ê Press the On/Off button.
The server is switched on, performs a system test and boots the
operating system.
Switching the server off
The power-on indicator (see figure
lights up green.
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The AC
connected indicator lights up green.
I
If the operating system does not switch the server off automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal for power button override.
V
CAUTION!
There is a risk that data may be lost.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Timer-controlled switch-on/off
Using the ServerView Operations Manager or iRMC S4, you can configure
that the server is switched on/off controlled by timer.
– Ring indicator
The server is switched on by an internal or external modem.
– Wake up On LAN (WOL)
The server is switched on by a command via the LAN (Magic Packet
72
or section
75).
9 on page 59
Operating Manual
"Configuring the
"Configuring the server and
and figure 10 on page 59)
TM
).
RX1330 M3