A) Connecting The Aerial; B) Connecting The Line Outputs; C) Aux In Connection - Renkforce RSD-1802 Operating Instructions Manual

In most vehicles the cables for the electric connection and the connection of the speakers have
been laid directly to the slot.
If this is not the case, please make sure that any cables placed later are secured by the respec-
tive on-board fuses (see vehicle operation manual).

a) Connecting the Aerial

• Connect the aerial plug of your vehicle with the aerial socket at the back of the radio (socket next to the
cinch terminals).
• If your vehicle has a different aerial plug, please use a suitable adapter, available in specialist shops.

b) Connecting the LINE Outputs

The SD tuner has LINE outputs for connecting a power amplifier.
For the connection of the cinch sockets only use the shielded cinch wires. Use of any other
cables may cause interferences.
Keep the distance of the cables as short as possible.
Do not place the cables near other cables to avoid interferences in the cables.
To avoid distortions or mismatchings that could damage the device, cinch connector must only
be connected to devices with the suitable cinch terminals. For this, observe also the connection
information in the section "Technical Data".
• Connect the cinch sockets at the rear of the casing to the power amplifier inputs.
The red socket is a terminal for the right channel
The white socket is a terminal for the left channel

c) AUX IN Connection

You can connect an external audio device (e.g. portable MP3 player) to the port AUX IN (4) whose signal is
played back via the vehicle speakers.
• Connect the port AUX IN (4) with the audio output of the external device.
37