Dmx Linking - Chauvet colorado 1 solo Quick Reference Manual

COLORado 1 Solo QRG
AC Power
Power Linking
AC Plug

DMX Linking

DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
You can link up to 24 COLORado 1 Solo products at 120 V, 40 products at 208 V,
or 45 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
·
To eliminate unnecessary wear and improve its lifespan, during periods
of non-use completely disconnect the product from power via breaker
or by unplugging it.
·
When using this product in an outdoor IP65 type environment, be sure
to use IP65 (or higher) rated power cables and secure unused ports
with attached IP65 covers.
The COLORado 1 Solo will work with a DMX controller using a 5-pin DMX
serial connection.
www.chauvetprofessional.com.
The COLORado 1 Solo uses a 3- or 5-pin DMX data connection for its DMX
personalities: HSIC, SSP, TOUR, TR16, and STD.Y. See the User Manual for
information about connecting and configuring the product for DMX operation.
When using this product in an outdoor IP65 type environment, be sure to use
IP65 (or higher) rated data cables and secure unused ports with attached IP65
covers.
Note: For optimum control of the 16-bit dimming channels in the TR16 and
STD.Y personalities, be sure that both dimming curves in SETTING >
DIMMER are set to OFF.
The COLORado 1 Solo uses the DMX data connection for its Master/Slave mode.
See the User Manual for information about connect and configure the product for
master/slave operation.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
A DMX Primer
3
Screw Color
Brown Yellow/Brass
Blue Silver
Green
is available
EN
from