Installing The Range; Anti-Tip Device Installation; Final Installation - Kenmore 721.9604 series Installation Manual

INSTALLING THE RANGE

Replace the access cover on the back of the range. To
replace the wire cover, insert the two tabs into the openings
located below the opening and tighten the three screws.
Access cover

ANTI-TIP DEVICE INSTALLATION

Tip - Over Hazard
A child or adult can tip the range and be
killed. Verify the anti-tip bracket has been
installed. Ensure the anti-tip bracket is
engaged when the range is moved.
Do not operate the range without the anti-
tip bracket in place. Failure to follow these
instructions can result in death or serious
burns to children and adults.
To check visually that leveling leg is inserted into
bracket, grasp the top rear edge of the range
and carefully attempt to tilt it forward.
Screw must
enter wood
or concrete
1. Locate the bracket using the template
An Anti-tip bracket is packaged with template. The
instructions include necessary information to complete
the installation.
Read and follow range installation instruction sheet
(template).
2. Level the range
Level the range by adjusting the leveling legs with a
wrench. Extending the legs slightly may also make it
easier to insert the rear leg into the anti-tip bracket.
WARNING
bracket
Leveling
bracket
leg
Anti-tip
Wall plate
bracket
Leg
leveler
Raise
range
Use a level to check your adjustments. Place the level
diagonally on the oven rack, and check each direction for
level.
First check direction .
After check direction .
If the level doesn't show
level on the rack, adjust
the leveling legs with a
wrench.

FINAL INSTALLATION

• M ove range close enough to the opening to plug into the
receptacle.
• S lide range into position insuring that the left back leg
Leveling
slides under the anti-tip bracket. Range should sit flush
leg
against the back wall when properly installed.
• C arefully attempt to tip range forward to insure that the
anti-tip bracket is engaged properly. If properly installed,
the anti-tip bracket will prevent the range from being
tipped. If the range can be tipped, reinstall the range
until the bracket is properly engaged and the range will
not tip forward.
• T urn on electrical power. Check the range for proper
operation as described in owner's manual.
INSTALLING THE RANGE
Lower
range
level
11