Samson 3730-3 Safety Manual page 3

Purpose of this manual
The Safety Manual SH 8384-3 contains information relevant for the use of the Type 3730-3
Positioner in safety-instrumented systems according to IEC 61508 and IEC 61511. The safety
manual is intended for planners, constructors, and operators of safety-instrumented systems.
NOTICE
!
Risk of malfunction due to incorrect mounting, connection or start-up of the device.
Refer to the Mounting and Operating Instructions EB 8384-3 on how to mount the positioner,
perform the electric and pneumatic connections as well as start up the positioner.
Observe the warnings and safety instructions written in the Mounting and Operating
Instructions EB 8384-3.
Further documentation
The documents listed below contain descriptions of the start-up, functioning, and operation of
the positioner. You can download these documents from the SAMSON website. The
documents marked with an asterisk (*) are supplied with the positioner either in printed or
electronic form.
Type 3730-3 Positioner with HART
T 8384-3:
u
EB 8384-3*:
u
KH 8384-3*:
u
KA 8384-2/3*: Quick guide
u
EXPERTplus diagnostics (Type 3730-3 Positioner in firmware version 1.50 and higher)
T 8389:
u
EB 8389*:
u
EXPERT diagnostics (Type 3730-3 Positioner up to firmware version 1.49)
+
T 8388:
u
EB 8388:
u
Note
In addition to the positioner documentation, observe the documentation for the pneumatic
actuator, valve, and other valve accessories.
SH 8384-3 EN
communication
®
Data sheet
Mounting and operating instructions
Configuration instructions for HART
Data sheet
Operating instructions
Data sheet
Operating instructions
communication
®
3