Table of Contents
Advertisement
11. Windows should now prompt you to install the "Thomson USB CDC Devices". Click "Next" to
install the driver.
At this point your PC needs to copy Windows 2000 specific files. If these files are not located
on your hard drive, you may need to insert your Windows 2000 installation media (i.e.,
Windows 2000 CD-ROM), but first remove the EMTA CD-ROM.
12. After the Windows specific files are copied, you may be asked for another USB driver file
named "NETRCACM.SYS," located on the EMTA CD-ROM. Remove the Windows 2000 CD-ROM
(if necessary), and reinsert the CD-ROM that accompanied your EMTA.
13. Click on "Finish" to complete the process.
14. The installation is now complete. To validate a proper installation, perform the following
instructions:
A. Click on the "Start" icon in the lower left-hand corner of your screen.
B. Select "Settings," followed by "Control Panel." The "Control Panel" window appears.
C. Double-click on the "System" icon, select the "Hardware" tab, and choose "Device
Manager."
D. Scroll down the list until you come to "Network Adapters." Double-click on "Network
Adapters."
E. The "RCA Digital Cable Modem" should exist. If the "RCA or Thomson Digital Cable
Modem" does not exist, the EMTA was NOT installed correctly. Please install again.
Illustrations contained in this document are for representation only.
Chapter 2: Advanced Information
17
Advertisement
Table of Contents
