Display Range; How To Display The Targets Within A Specific Sector - Furuno 1815 Operator's Manual

5.6

Display Range

You can set the AIS system to show only those AIS targets within the range you set.
The setting range is 0.1-36 nm for MODEL 1835, 0.1-48 nm for MODEL 1935, 0.1-64
nm for MODEL 1945. Actual range depends on the AIS Transponder. If the target sort-
ing method is selected to [Range], the target data within the range set here is trans-
mitted to this radar.
1. Press the MENU/ESC key to open the menu.
2. Select [AIS], then press the ENTER key.
3. Select [Range], then press the ENTER key.
4. Set the display range, then press the ENTER key.
5. Press the MENU/ESC key to close the menu.
Note: The unit of measurement for range is NM.
5.7 How to Display the Targets within a Specific Sec-
tor
You can display AIS targets only within a specific sector. If the target sorting method
is selected to [Sector], the target data within the sector set here is transmitted to this
radar.
1. Press the MENU/ESC key to open the menu.
2. Select [AIS], then press the ENTER key.
3. Select [Sector Start], then press the ENTER key.
4. Set the start point for the sector, then press the ENTER key.
5. Select [Sector End], then press the ENTER key.
6. Set the end point for the sector, then press the ENTER key.
7. Press the MENU/ESC key to close the menu.
5. AIS OPERATION
5-5