Door Reversibility - Zanussi ZRB23200XA User Manual

Levelling
The appliance should be level in order to
eliminate vibration. To make the appliance
level, it should be upright and both adjusters
should be firmly contacted with the floor. You
can also adjust the level by screwing out the
appropriate level adjuster at the front (use
your fingers or a suitable spanner).

Door reversibility

The side at which the door opens can be
changed from the left side (as supplied) to
the right side,if the installation site requires.
Before you start lay the refrigerator on its
back in order to gain access to the base, you
should rest it on soft foam or similar material
to avoid damaging the cooling pipes at the
rear of refrigerator.
1. Stand the refrigerator, use a flat bladed
screw driver to remove the 4 screw
covers on the refrigerator lid.
2. Unscrew and lift the lid from the rear
and remove it, them lift the upper door
and place it on a padded surface to
prevent it getting scratched.
3. Remove the upper hinge core, transfer
it to left side and tighten securely.
24
4. Remove the two flange screw, then
remove the middle hinge that hold the
lower door in place. Lift the lower door
and place it on a padded surface to
prevent scratching it.
5. Remove the hinge hole cover from the
right holes as illustrated and transfer
them to the uncover hole at the left side.
6. Remove the hinge hole cover from the
right holes as illustrated and transfer
them to the uncover hole at the left side.
7. Unscrew and remove the bottom hinge
pin, turn the bracket over and replace it.
Refit the bracket fitting the bottom
hinge pin. Replace both adjustable feet.
Transfer the lower door to the opposite
position. Secure the door's level, put
the bottom hinge pin into the lower hole
of the door, then tighten the bolts.
www.zanussi.com