Technical Information - Zanussi ZRB23200XA User Manual

Problem
Unusual noises
The compressor does not start
immediately after changing the
temperature setting.
If the malfunction shows again, contact the
Service Center.
Below data are necessary to help you quickly
and correctly. Write the necessary data here,
refer to the rating plate.
Model description ................................................
(Mod.)
Produkt number
(PNC)
Serial number
(S.N.)
Replacing the lamp
Caution! Before replacing the lamp,
disconnect the appliance from mains
power supply.

Technical information

For further technical information please refer to the rating on the internal left side
of the appliance and in the energy label.
Dimensions
Height
Width
Depth
Rising time
22
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
This is normal, no error has
occurred.
................................................
................................................
mm
mm
mm
hours
Possible cause
Failure to do so could result in electrical
shock or personal injury.
Follow below process to replace the lamp:
1. Use the cross screw driver to take the
screws out.
2. Remove the light cover.
3. Light Bulb-screw out the bulb ac-
cording to the direction shown in the
picture
4. Replace with a 10 watt-refrigerator bulb
that is of the same shape and size.
5. Replace the light cover.
Solution
Re-adjust the feet.
Move the appliance slightly.
It necessary, caretully move the
component out of the way.
The compressor will start after a
period of time.
1687
558
613
10
www.zanussi.com