HotWire TR8100V Instructions

Turning your heating on and off Automatically

Step One: Set The Time and Day:
Press clock button, and time display will start flashing
Use the up and down buttons to adjust .Holding the
buttons down will increase or decrease the time in 15 minutes increments.
Hotwire Thermostat
Press the OK button once the time is set.
Press the day button to get to the current Day of the week.
Press OK button to exit.
Step Two: Set the thermostat to Auto mode
Ensure that the thermostat is on Auto mode.
Step Three: Programming your schedules
If you set your thermostat to 7 day programmable mode
(1). Press Prog button.
(2). Press up or down buttons to select the day you wish to start programming. then press Prog.
(hold up button to select all days of the week, to cancel, hold up button again.)
(3). Press up or down buttons to adjust the time you wish the program 1 event to commence
for the currently selected day. and then press Prog button.
(4). Press up or down buttons to set the temperature for this time period,then press Prog.
(5). Set time and temperature for the next time period. Repeat step(2) and (3) for each
time period.
(6). Press OK to save and exit.
If you set your thermostat to 5+2 day programmable mode
(1). Press Prog button.
(2). Press up or down buttons to adjust the time you wish the program 1 event to commence
for the week days( from Monday to Friday). and then press Prog button.
(3). Press up or down buttons to set the temperature for this time period,then press Prog.
(4). Set time and temperature for the next time period. Repeat step(2) and (3) for each
time period. and then press Prog button.
(5). Press up or down buttons to adjust the time you wish the program 1 event to commence
for the weekends( Saturday and Sunday). and then press Prog button.
(6). Press up or down buttons to set the temperature for this time period,then press Prog.
(7). Set time and temperature for the next time period. Repeat step(5) and (6) for each
time period.
(8). Press OK to save and exit.
Key Lock & Unlock
Press and hold to lock the thermostat. A lock
Press and hold to unlock the thermostat. The lock icon will disappear.
* Note no program changes are possible while the unit is locked.
Temporary Temperature Override
In Auto mode, to temporary override the current setpoint temperature,
1. Press up or down button once, the set temperature starts flashing.
2. Press up or down button again to adjust the set temperature.
3. Press OK button to confirm the setting with OVERRIDE shown.
Now your thermostat will maintain the new set temperature until the next setpoint.
To cancel the override setting, press Del button once.
Resetting factory defaults
Your thermostat has the ability to reset all settings to the factory defaults. If you
are certain you want to do this:
In standby mode(when thermostat is turned off), press and hold Clock button and
Day button for 5 seconds until --:-- is shown(shown for 5 seconds only)
Instructions
To select Auto use the mode button
Model Number: TR8100V
icon will display.
AUSTRALIA
Australia
Hotwire Heating
Verve Distribution
WWW.HOTWIREHEATING.COM.AU
6 Todd St
Port Adelaide SA 5015
www.vervedistribution.com.au
New Zealand
The Heating Company
PO BOX 420
Whitianga NZ
www.hotwire.co.nz
NEW ZEALAND
The Heating Company
www.theheatingcompany.co.nz/