Advertisement
Configure DMP IP Address and Account
1.
Plug HDMI cable into Display/TV & then into DMP
2. Plug Ethernet cable into DMP and then into network wall outlet (Requires DHCP)
3.
Plug DMP into the power source
4.
Turn on the Display/TV
5. Turn on the DMP & you should see a Cisco Welcome Screen for only 30 Seconds (if missed, restart
DMP)
6. Take note of the DMP IP Address (write it down, take a picture, utilize your superior memory bank,
etc.).
By default, the Cisco DMP is set to DHCP. Please make sure that your network has DHCP enabled for the
initial setup on the DMPs. If your network does not support DHCP, you can plug the DMP into a standard
router to get the initial IP Address.
Setup Cisco's DMP Admin
1.
Enter the DMP IP Address from Cisco Welcome Screen (ex. - http://171.71.227.181)
2. When you go to your DMP IP Address, you will be asked to enter Username and Password
(Username = admin, Password =default)
a.
The DMP may ask you to create a new password to access the device. If your DMP prompts
for this, enter a new password and write it down. It is easier to use this same password when
setting up all DMPs on your network. Also, you will need this password later on in the setup
process.
Click on left navigation links, update settings below:
i.
Select Network
3.
To make changes permanent, click Save Configuration and Restart DMP at the bottom of the
configuration page
DMP IP Addresses are unique to your player and cannot be used more than once.
1.
Set Dynamic IP Addressing to Disabled (Only leave this option set to
enabled if you have reserved the DHCP address for your device. If the
DMP's IP changes, its communication with CCHD with be severed.)
2. Enter appropriate network configuration data in the field below. (skip this
step is a DHCP IP has been reserved and the DHCP drop down is set to
enabled).
3.
Click Apply at the bottom of the configuration page
Advertisement
