Setting The Sharing Function - Fujitsu l2010 User Manual

Setting the sharing function

Set the sharing function to make file and/or printer sharing with other network-connected personal
computers valid.
The setting operation is not required unless the sharing function is to be used.
The folder and printer for which the sharing function has been set will be usable from any personal
computer present on the network.
Setting of Microsoft network service for common use
1. Click the "Start" button and "Control panel" in this order.
2. Click the "Network and Internet connection".
The table of network connection is shown on the screen.
3. Click the "Wireless network connection" in the table by the right button of the mouse,
and then click the "Properties" in the menu shown next.
4. Make sure that there is a check mark (
sharing for Microsoft network" in the table of "This connection uses the following
item", and then click the "OK".
If the check box is
Critical Points
If the "File and printer sharing for Microsoft network" is not shown on the screen, install it
following the procedure mentioned below.
1. Click the "Install".
The "Select type of network component" window appears on the screen.
2. Click the "Service" in the table and then click the "Add".
The "Select network service" window appears.
3. Click the "Common use of file and printer for Microsoft network" in the table, and then
click the "OK".
4. The "File and printer sharing for Microsoft network" is shown in the table of "This connection
uses the following item". After confirming the check mark
sharing for Microsoft network", click the "Close".
, click to turn it into
) in the check box of the file and printer
and click the "OK".
for the "File and printer
53