Fujitsu l2010 User Manual page 101

The power management function is not executed.
Checkpoint
Is Power Savings set to off in
the BIOS setup?
Data cannot be read from the CD-ROM drive.
Checkpoint
Is the CD-ROM correctly set?
Is there any dirt, condensa-
tion or water on the CD-
ROM?
Is the CD-ROM scratched or
extremely warped?
Are you using a non-standard
CD-ROM?
Is the CD-ROM drive unit
securely installed?
The CD cannot be ejected from the CD-ROM.
Checkpoint
Is it in operating mode?
Super disk cannot be ejected.
Checkpoint
Is the computer in operation?
Cause and Solution
Reset the BIOS setup.
Cause and Solution
Set the CD-ROM correctly with its label facing upwards.
Wipe it from the center outwards with a dry, soft cloth.
Replace the CD-ROM.
Use a CD-ROM which conforms to the standards.
Securely install the CD-ROM drive unit.
Cause and Solution
The CD can only be ejected when the personal computer main
unit is in operating mode because its CD- ROM drive has an
electronic lock. Check that the personal computer main unit is in
operating mode and press the EJECT button. If for some reason
the CD tray does not come out even when you press the EJECT
button, insert a clip or something into the hole to the right of the
EJECT button and pull the tray out.
If the tray doesn't still come out, click the CD-ROM icon in the
"My Computer" window with the right button of the mouse and
then click "EJECT".
Cause and Solution
Since the super disk drive secures the super disk by the
electronic lock, the disk can be ejected only when the computer
is in the operation status.
If the super disk cannot be ejected for some reason, insert a
thin linear wire such as a straightened paper clip or the like into
the emergency disk ejecting hole and push it into the depth. The
disk will be resultingly ejected from the drive.
85