Connection To The Network; Setting The Network - Fujitsu l2010 User Manual

SECTION 2

Connection to the Network

This section explains connection to the network.

Setting the network

IMPORTANT
If a cable LAN has been set up, be careful not to compete with the cable LAN setting. If
wireless LAN setting compete against the existing cable LAN setting, the network fails
in normal communication.
During connection with a network (Internet, etc.) using the LAN function, it is advised
not to enter the personal computer into the standby or hibernate mode, because the
personal computer fails in normal connection with a network (Internet, etc.) depending
on the use environment.
When the personal computer is not used, be sure to shut down the system.
When connecting with an existing network, consult with the administrator of the network
about setting in detail.
For connecting with the Internet by ADSL through a station such as an optional wireless
broad-band rooter, etc., refer to the manual of the station and other manuals provided
by the provider and line enterprise for setting.
TCP/IP setting
1. Click the "Start" button and "Control panel".
2. Click the "Network connection".
The table of network connections appears on the display.
3. Click the "Wireless Network Connection" appearing in the table by the right button of
the mouse, and click the "Properties" in the menu.
4. Click the "Internet protocol (TCP/IP)" in the table of the "This connection uses the
following item", and then click the "Properties".
5. Set an IP address.
50