Danfoss VLT Micro Drive FC 51 Quick Manual page 21

Quick Guide
1.7.2 Mains Supply 3x200–240 V AC
Normal overload 150% for 1 minute
Frequency converter
Typical shaft output [kW]
Typical shaft output [hp]
Enclosure protection rating IP20
Output current
Continuous (3x200–240 V) [A]
Intermittent (3x200–240 V) [A]
Maximum cable size:
(Mains, motor) [mm 2 /AWG]
Maximum input current
Continuous (3x200–240 V) [A]
Intermittent (3x200–240 V) [A]
Maximum mains fuses [A]
Environment
Estimated power loss [W]
Best case/typical 1)
Weight enclosure IP20 [kg]
Efficiency [%]
2)
Best case/typical
Table 1.7 Mains Supply 3x200–240 V AC
1) Applies for dimensioning of frequency converter cooling. If the switching frequency is higher than the default setting, the power losses may
increase. LCP and typical control card power consumptions are included. For power loss data according to EN 50598-2, refer to www.danfoss.com/
vltenergyefficiency.
2) Efficiency measured at nominal current. For energy efficiency class, see chapter 1.8.1 Surroundings. For part load losses, see www.danfoss.com/
vltenergyefficiency.
MG02BB02
Quick Guide
PK25
0.25
0.33
M1
1.5
2.3
2.4
3.2
14.0/
20.0
1.1
96.4/
94.9
Danfoss A/S © 05/2016 All rights reserved.
PK37 PK75 P1K5
0.37 0.75 1.5
0.5 1 2
M1 M1 M2
2.2 4.2 6.8
3.3 6.3 10.2
4/10
3.5 6.7 10.9
4.6 8.3 14.4
See chapter 1.3.3 Fuses
19.0/ 31.5/ 51.0/
24.0 39.5 57.0
1.1 1.1 1.6
96.7/ 97.1/ 97.4/
95.8 96.3 97.2
1
P2K2 P3K7
2.2 3.7
3 5
M3 M3
9.6 15.2
14.4 22.8
15.4 24.3
23.4 35.3
72.0/ 115.0/
77.1 122.8
3.0 3.0
97.2/ 97.3/
97.4 97.4
19
1