Installation Of Group I I For The Children; Who Weigh 15-25Kg; Installation In The Vehicle - Phil & Teds columbus User Manual

4.3 Installation of Group II for children

who weigh 15-25kg

• Before the installation, please take away the Harness
system of baby car seat. (4a) Note: The Baby insert,
Harness strap, Harness buckle, Buckle pads and Shoulder
pads should be stored away safely for future use (see
5.1 Removing the S-point harness system and cover).
Do not to use any load bearing contact points
otherthan those described in the instructions
and marked in the child restraint. The belt
must be routed as shown in the instructions.
Note: In the interest of safety the seatbelt
retractor must be switched to ALR mode
when using the car seat in group 2 & 3.
Please refer to your vehicle user instructions
for further information.
• Put the shoulder belt through the shoulder belt guide under the headrest. (4k)
• Place your child into the car seat and pass the belts through the bottom of the
armrest. Fasten the car belt with an audible sound "click". (4l) (4m)
• Make sure the Lap belt is stretched as low as possible over the child's hips within the
Belt guides, and fastened into the buckle. The Shoulder belt must cross midway
between child's shoulder and neck. (4n)
4j
4l

Installation in the vehicle

4k
4m
4n
19