Safety; Instructions For Safe Operations; Warning; Hazards - ToronTek E400 User Instructions

1. Safety

1.1. Instructions for Safe Operations

 Inspect the main unit and all accessories periodically to ensure that there is no visible damage
that may affect the patient's safety, and monitor the performance of cables and transducers. It is
recommended that the device should be inspected at least once a week. If there is obvious
damage, stop using the device.
 Necessary maintenance must be performed by qualified service engineers ONLY. There are no
user serviceable parts and users are not permitted to service the device by themselves.
 The Oximeter must not be used together with accessories not specified in the User Manual.
Only accessories specified or recommended by the manufacturer can be used with this device.
 This product is calibrated before leaving the factory.

1.2. Warning

Explosive hazard—DO NOT use the Oximeter in an environment with flammable gas, such as
some ignitable anesthetic agents.
DO NOT use the Oximeter while the patient is measured by MRI and CT.
Be careful with the use of the wrist strap. Improper use of the wrist strap will cause damage not
covered under the manufacturer's warranty. Swinging the device by the wrist strap will void the
warranty. Please do not use the wrist strap if allergic to the material.
The disposal of this instrument and its accessories and packaging (including batteries, plastic
bags, foams and paper boxes) should follow local laws and regulations.
Please check the packaging before use to make sure the device and accessories are in complete
accordance with the packaging list or else the device may not work normally.
Use only accessories approved by the manufacturer or else risk damaging the device.
Please only use the battery charger which is accompanies by the product and is in compliance
with the requirements of IEC 60601-1. Using a different charges might damage the device.
Do not use the device while it is charging.

1.3. Hazards


Keep the Oximeter away from dust, vibrations, corrosive substances, explosive materials,
high temperatures and moisture.

Stop operating the Oximeter if it gets wet.

DO NOT use the device immediately after moving it from a cold environment to a warm or
humid environment.

DO NOT operate the keys on the front panel with sharp objects.

High temperature and high pressure steam disinfection of the Oximeter is not permitted.R
efer to the User Manual in the relative chapter (7.1) for instructions on cleaning and
disinfection.
TORONTEK-E400 Pulse Oximeter
1