BAS 100B/W Instruction Manual page 125

Sensitivity = 1 µA/V
Specific Parameters
Real Time Integrator = Off
Quiet Time (sec) = 2
Comments
a) The Sample Interval is the time resolution of the experiment.
b) The number of data points recorded in an experiment must be less than or
equal to 8000, which is the data storage limit. If the product exceeds 8000,
then the Run Time is automatically adjusted to an acceptable value.
c) A Precondition potential can be applied for the Precondition Time before
the start of the experiment.
d) When enabled, the Real Time Integrator adds all the current values to give
the charge accumulated.
Graphics Menu
Single Graph displays the current vs. time plot.
Analysis Menu
Results Graph is disabled for TB.
Mode = DPTB
General Parameters
Initial E (mV) = 0
Final E (mV) = 0
Pulse Width (msec) = 250
Pulse Period (msec) = 500
Sample Width (msec) = 200
Run Time (sec) = 4000
Sensitivity = 1 µA/V
Specific Parameters
Quiet Time (sec) = 2
100 mA/V to 100 nA/V (10 pA/V with the
Low Current Module)
Off/On
0 to 65535
-3276 to 3276
-3276 to 3276
25 to 20000
50 to 40000
1 to 19995
1 to 65535
100 mA/V to 100 nA/V (10 pA/V with the
Low Current Module)
0 to 65535
10-57