Sherwood RX-4109 Operating Instructions Manual page 16

Tuning to preset stations
1.
After selecting the tuner as an input source, select the preset mode.
or
2.
Select the desired preset number.
or
Listening to FM stereo broadcasts
Scanning preset stations in sequence
• Then "PRESET" lights up.
• When using the NUMERIC buttons on the
remote control.
Examples)
For "3"
For "15"
For "30"
• When selecting the desired preset number with
the NUMERIC buttons, the desired preset station
will be tuned to automatically without selecting
the preset mode.
• While listening to FM broadcasts, press the FM
MODE button.
• Each time this button is pressed, the FM mode
changes as follows:
→ Stereo mode : "ST" lights up.
Mono mode : "ST" goes off. ←
• When FM stereo broadcasts are poor because
of weak broadcast signals, select the FM mono
mode to reduce the noise, then FM broadcasts
are reproduced in monaural sound.
• The receiver will start scanning the stations in
the preset sequence.
• At the desired station, press this button again to
stop scanning.
16
within 2 seconds