Sherwood RX-4109 Operating Instructions Manual page 13

Adjusting the tone (bass and treble)
8.
Enter the tone mode.
9.
At the desired tone mode, adjust the tone as desired.
10.
To listen to a program source without the tone effect.
Adjusting the sound volume balance
11.
Enter the balance mode.
12.
Adjust the sound volume balance between the left and right speakers.
• Each time this button is pressed, the
corresponding tone mode is selected and shown
for 3 seconds as follows:
▄ Note
• When the tone direct function is activated, the
tone mode cannot be entered and "TON DIR"
flickers for 2 seconds.
• If the tone display disappears, start from the step
8 again.
▄ Note
• Extreme settings at high volume may damage
your speakers.
• In general, the bass and treble levels are
adjusted to 0.
• "TON DIR" is displayed, "DIRECT" lights up and
the sound that bypasses the tone circuitry will be
heard.
• To cancel the tone direct function, press this
button again to display "TON CTRL", and then
"DIRECT" goes off.
• "BAL" and the balance level is displayed for 3
seconds.
• If the balance display disappears, start from the
step 11 again.
▄ Note
• In general, the balance level is adjusted to 0.
13