Table of Contents
Advertisement
TRENDnet User's Guide
PVC Auto Search
Setup > Internet Setup > PVC Auto Search
To configure the PVC Auto Detection function, you can add or delete the auto PVC
Search Table.
1. Log into your router management page (see "Access your router management page"
on
page 23).
2. Click on Setup, click on Internet Setup, and click on PVC Auto Search.
3. Review the settings and click Apply to save changes
Change your router IP address
Setup > Local Network > LAN Interface
© Copyright 2015 TRENDnet. All Rights Reserved.
In most cases, you do not need to change your router IP address settings. Typically, the
router IP address settings only needs to be changed, if you plan to use another router in
your network with the same IP address settings, if you are connecting your router to an
existing network that is already using the IP address settings your router is using, or if
you are experiencing problems establishing VPN connections to your office network
through your router.
Note: If you are not encountering any issues or are not faced with one of the cases
described above or similar, it is recommended to keep your router IP address settings as
default.
Default Router IP Address: 192.168.10.1
Default Router Network: 192.168.10.0 / 255.255.255.0
1. Log into your router management page (see "Access your router management page"
on
page 23).
2. Click on Setup, and click on Local Network.
3. Review the settings and click Apply to save changes.
IP Address: Enter the new router IP address. (e.g. 192.168.200.1)
Note: You will need to access your router management page using your new router
IP address to access the router management page. (e.g. Instead of using the default
http://192.168.10.1
using your new router IP address will use the following format
using your new router IP address http://(new.router.ipaddress.here) to access your
router management page.
Subnet Mask: Enter the subnet mask of the router (e.g. 255.255.255.0)
TEW-723BRM
25
Advertisement
Table of Contents
