Ventilation49; Starting-Up And Appliance Management En; Before The First Use; Induction Principle - BORETTI BIK-97 Operating Instructions Manual

Residual heat indication

After the switch off of a heating zone or the
complete stop of the hob, the heating zones
are still hot and indicates [H] on the display.
The symbol [H] disapears when the heating zo-
nes may be touched without danger.
As far as the residual heat indicators are on
light, don't touch the heating zones and don't
put any heat sensitive object on them . There
are risks of burn and fire.
Starting-up and appliance management

Before the first use

Clean your hob with a damp cloth, and then dry the surface thoroughly. Do not use detergent
which risks causing blue-tinted colour on the glass surface.

Induction principle

An induction coil is located under each heating zone. When it is engaged, it produces a variable
electromagnetic field which produces inductive currents in the ferromagnetic bottom plate of the
pan. The result is a heating-up of the pan located on the heating zone.
Of course the pan has to be adapted :
• All ferromagnetics pans are recommended (please verify it thanks a little magnet): cast iron and
steel pans, enamelled pans, stainless-steel pans with ferromagnetic bottoms...
• Are excluded : cupper, pure stainless-steel, aluminium, glass, wood, ceramic, stoneware,...
The induction heating zone adapts automatically the size of the pan. With a too small diameter
the pans doesn't work. This diameter is varying in function of the heating zone diameter.If the pan
is not adapted to the induction hob the display will show [U].

Starting-up

• Start-up/ switch off the hob :
Action
To start :
To stop :
• Start-up/ switch off a heating zone :
Action
Increase power
Decrease power
Stop
Control panel
touch the key [0/I]
touch the key [0/I]
Control panel
touch key [+]
touch key [-]
touch simultaneous [+] and [-]
Ventilation
The cooling system is fully automatic. The
cooling fan starts with a low speed when the
calories brought out by the electronic system
reach a certain level. The ventilation starts his
high speed when the hob is intensively used.
The cooling fan reduces his speed and stops
automatically when the electronic circuit is
cooled enough.
Display
[0]
nothing or [H]
Display
[4] to [9]
[9] to [1]
[0] or [H]
Control light
switch on
switch off
49
NL
FR
ES
EN