Table of Contents
Advertisement
Available languages
Available languages
Troubleshooting
If you encounter problems with this unit, check the following before requesting service.
1 Refer to "Trouble" below.
2 Refer to the "Troubleshooting" section in the "Detailed User Guide".
If you have difficulties operating the unit, refer to the detailed descriptions in the
"Detailed User Guide".
3 This unit is a microcomputer-controlled device. Electrostatic discharge, external
noise and interference (from a TV, a radio, etc.) might prevent it from functioning
properly.
In such a case, reset the unit.
A Turn off the power.
B Remove the AC adapter and battery pack from this unit, reattach them, turn
on the power.
4 If the above do not solve the problem, consult your nearest JVC dealer or JVC
service center.
Trouble
Trouble
POWER/CHARGE
lamp starts blinking
when the power is
turned off.
Recording cannot be
performed.
Recording stops
automatically.
Unable to record
properly in the
Intelligent Auto mode.
Sound or video is
interrupted.
22
Action
The battery pack is being charged.
0
Check the A/B button.
0
Set to the recording mode by tapping
0
the "<<CAM" button.
Turn off this unit, wait for a while, and
0
turn it on again. (This unit stops
automatically to protect the circuit
when the temperature rises.)
Recording stops automatically after
0
12 hours of continuous recording.
When there are multiple light sources
0
and depending on the shooting
conditions, exposure and focus may
not be adjusted correctly in the
Intelligent Auto mode. In this case,
adjust the settings manually.
Sometimes playback is interrupted at
0
the connecting section between two
scenes. This is not a malfunction.
Page
8
13
16
-
-
-
-
Advertisement
Chapters
Table of Contents
