Zp.uini - Mitsubishi Electric QJ71MB91 User Manual

10
DEDICATED INSTRUCTIONS

10.4 ZP.UINI

This instruction can change the intelligent function module switch setting of the QJ71MB91
(the mode, communication speed, transmission details, and/or station No.)
Setting Internal device
data (System, user)
Bit Word
(S1) -
(D1)
[Instruction symbol] [Execution condition]
ZP.UINI
(1) Setting data
Setting data
Head I/O number of the module
"Un"/Un
(00 to FE
H
(S1) Head number of the device where control data is stored
The device that is turned ON for one scan on completion of the
(D1) instruction
(D1)+1 also turns ON when the instruction completes in error.
Table10.14 Devices available for the UINI instruction
Link direct device
J \
File resister
Bit Word
Figure 10.16 Configuration of UINI instruction
* 1 If the originating station is a Basic model QCPU (function version B or later), or Universal model
QCPU, "" (double quotation) of the first argument can be omitted.
Table10.15 Setting data of UINI instruction
Setting details
: Upper 2 digits of the I/O number in 3-digit notation)
H
* 1 The setting side is as described below.
User : Data are set by the user before dedicated instruction execution.
System: The programmable controller CPU stores the result of dedicated instruction execution.
Local devices and program-based file registers are not available as the devices used
for setting data.
Available device
Intelligent function
Index register
module device
U \G
-
-
"Un"
ZP.UINI
Setting side
User, system
Constant
Others
Zn
K,H $
(S1) (D1)
*1
Data type
String/
User
BIN 16 bits
BIN 16 bits
System Bit
10
10.4 ZP.UINI
9
10
11
- 25