Mitsubishi Electric QJ71MB91 User Manual page 259

9
PROGRAMMING
(3) Parameter settings
The following setting is required to perform the communication shown in (2).
(a) Intelligent function module switch setting
Figure 9.28 Intelligent function module switch setting (When using GX Configurator-MB)
Figure 9.29 Intelligent function module switch setting (When not using GX Configurator-MB)
(b) Network parameter
Figure 9.30 Network range assignment (When using GX Configurator-MB)
Set the intelligent function module switches for the setting target, QJ71MB91, as
shown below. ( Section 6.6)
1) When using GX Configurator-MB
2) When not using GX Configurator-MB
Set the following network parameters for the MELSECNET/H remote master
station by GX Developer.
1) Network type
2) Starting I/O No.
3) Network No.
4) Total stations
5) Mode
6) Network range assignment
• When using GX Configurator-MB
9.3 Program Examples for Use in MELSECNET/H Remote I/O Network
: MNET/H (Remote master)
: 0000
H
: 1
: 1
: On line
9.3.1 Automatic communication parameters
9
10
11
9
- 30