Mitsubishi Electric QJ71MB91 User Manual page 163

7
PARAMETER SETTING
(3) Parameter setting procedure
Set the parameters by the following procedure.
Set the intelligent function module
switch's MODBUS device assignment
parameter starting method (switch 2,
bit 0) to ON.
(
Set function parameters to be used.
Automatic communication parameters
(
MODBUS device assignment
parameters
(
Automatic refresh settings
(
Write parameters to the
programmable controller CPU.
With the RUN/STOP switch set to
RUN, reset the programmable
controller CPU.
NO
Check the auto-refresh parameters,
the head input/output numbers, etc.
Start
Set parameters with
GX Configurator-MB?
YES
Section 6.6)
Section 8.4.1)
Section 8.4.2)
Section 8.5)
SP.PARA ERROR
occurred in the programmable
controller CPU?
YES
(To next page)
Figure 7.1 Parameter setting procedure
7.1 Parameter Settings and Setting Procedure
NO
Change MODBUS device
assignment?
YES
Set the intelligent function module
switch's MODBUS device assignment
parameter starting method (switch 2,
bit 0) to ON.
( Section 6.6)
Create a sequence program for
parameter setting of functions to be
used.
Automatic communication parameters
( Section 9.1.1, 9.2.1)
MODBUS device assignment
parameters
( Section 9.1.2, 9.2.2)
After writing the sequence program to
the programmable controller CPU,
reset the programmable controller
CPU
Put the programmable controller CPU
into the RUN status
1
2
NO
3
4
5
1)
6
7
8
7
- 2