9
PROGRAMMING
(3) Parameter settings
The following setting is required to perform the communication shown in (2).
(a) Intelligent function module switch setting
(b) MODBUS device assignment parameter
Set the intelligent function module switches for the setting target, QJ71MB91, as
shown below. (
Section 6.6)
Figure 9.16 Intelligent function module switch setting
1) When using GX Configurator-MB
Set MODBUS device assignment parameter in the Initial setting of GX
Configurator-MB. (
Set the values shown in the settings. (
Figure 9.17 MODBUS device assignment parameter
2) When not using GX Configurator-MB
Set MODBUS device assignment parameter from the sequence program.
(
This section (4))
9.2 Program Example for Normal System Configuration
Section 8.4.2)
This section (2) (b))
9.2.2 MODBUS device assignment parameters
9
10
11
9
- 16