Maximum/Minimum Values; Alarm Functions - Renkforce FT0100 Operating Instructions Manual

18. Maximum/minimum values

The weather station saves the extremes for the indoor/outdoor temperatures and indoor/outdoor humidity.
When clearing or resetting, all Min/Max values of the weather station or the outdoor sensors will be cleared.
• Push and hold the button "HISTORY" for approx. 3 seconds.
• The maximum values and the display MAX CLR flash in the display.
• To reset the maximum values, push the "SET" button. The max. display shows the current values.
• Briefly push the button "HISTORY" to display the minimum values. The minimum values and the indication MIN CLR flash
in the display.
• To reset the minimum values, push the "SET" button. The min. display shows the current values.
• Briefly push the button "ALARM" to leave the mode.

19. Alarm functions

The basic station offers the option of emitting an alarm signal (visually and acoustic) when a threshold is exceeded or
undercut. If press any button and the acoustic alarm will be switched off. The alarm function can be set for indoor tem-
perature, outdoor temperature (channel 1), indoor humidity, outdoor humidity (channel 1), dewpoint and and time alarm.
The outdoor sensors 2-8 are not considered in the alarm function.
The acoustic alarm signal can be deactivated. In that case, there will only be a visual alarm.
Observe that the value set for the upper limit (temperature, humidity, dewpoint) must be higher than the value for
the lower limit. Never swap the two values.
Change the values with the buttons "+" or "-". Keep the respective button pressed for quick adjustment.
Push the "SET" button to save the set value and switch to the next alarm function.
Use the button "ALARM" to activate or deactivate the alarm functions of the individual areas. The alarm function
is activated when the alarm symbol
outdoor temperature).
If you do not push any button for approx. 30 seconds, the settings made until then are saved and setting mode is
left.
The button "SNOOZE/LIGHT" leaves the alarm setting mode at any time, and press "SET" or "ALARM" button
return to normal mode.
Switching the button tone/alarm sound on or off
You can activate or deactivate the function for the button tone/alarm tone. Push and hold the button "ALARM" for
5 seconds for this.
BUZZOFF = sound off
BUZZON = sound on
is displayed next to the corresponding value (e.g. upper threshold of the
37