Specifications; Maintenance; Section 0). You Will Need To Re-Enter These Values After The Calibration Procedure It Complete - Renkforce WH2600 Operation Manual

7. Specifications

7.1 Wireless Specifications
Line of sight wireless transmission (in open air): 100meter

Update Rate: Outdoor Sensor: 16 seconds, Indoor Sensor: 64 seconds

Frequency: 433/868/915 MHz

7.2 Measurement Specifications
The following table provides the specifications for the measured parameters.
Measurement
Indoor Temperature
Outdoor Temperature
Indoor Humidity
Outdoor Humidity
Barometric Pressure
Light
Rain
Wind Direction
Wind Speed
7.3 Power Consumption
ObserverIp Receiver : 5V DC Adaptor (included)

Indoor Thermo-hygrometer-barometer sensor : 2xAAA batteries (not included)

Outdoor sensor array: 3xAA alkaline batteries (not included)


8. Maintenance

1. Clean the rain gauge once every 3 months as follows. Reference Figure 40.
Step 1: Make a note of the current rain totals by referencing the calibration panel (reference

Section 0). You will need to re-enter these values after the calibration procedure it complete.

Step 2: Pour water into the rain collector to moisturize the dirt inside rain bucket.
Step 3: Use an approximately 3 inch (80 mm) long cotton swab, and push the cotton tip through
the rain collector hole until is reaches the self emptying mechanism, and press until the
mechanism no longer rotates.
Step 4: Rotate the cotton swab back and forth, removing dirt from the tipping mechanism and
rain collector hole.
Step 5: Remove the cotton swab and flush with water to remove any remaining dirt.
Step 6: Re-enter the rain totals recorded in Step 1.
Range
0 to 60 °C
-40 to 65 °C sensor
-5 to 60 °C
battery range (alkaline)
1 to 99%
1 to 99%
300-1100hPa
(8.85 to 32.50 inHg)
0 to 400,000 Lux
0 – 9999mm
0 - 360 º
0-50m/s
Accuracy
± 1 °C
± 1 °C
± 5%
± 5%
+/-3hpa under 700-1100hPa
± 20%
± 10%
10º
± 1m/s or 10% (whichever is
greater)
Figure
- 2 - 8
Resolution
0.1 °C
0.1 °C
1 %
1 %
0.1hPa
1 Lux
0.03mm
1º
0.1 m/s