Advertisement
3. Connect some servo extension leads to your aileron servos and screw the servos into the servo bays
in the lower wings using self tapping screws. Fit the ailerons to the wings using the supplied hinges and
epoxy or CA glue. Ensure the ailerons move freely with no friction once the glue has set.
4. Glue the fiberglass control horns to the ailerons. Solder the supplied pushrods to the 2mm couplers then
screw a ball link onto the coupler thread. Install the control linkages to the ailerons as shown with a swing
keeper on the aileron horn end.
5. Use epoxy to secure the fiberglass horns to the strip ailerons ready for coupling the top and bottom
ailerons. Use the supplied self tapping screws to secure the rigging wire mounts into the wing as shown.
5
Advertisement
