Advertisement
S-2B
12. Trial fit the inter-plane struts to the wings. Then use the supplied screws to lock the inter-plane struts
and make sure the tabs are fully seated into the wings. Ensure the top/bottom wings are straight and true
to the fuselage and without any stress or distortion to the wings. Then epoxy the tabs into the wings when
everything fits and lines up perfectly.
13. Undercarriage components. Use a knife to cut out the covering on the side of the fuselage right beside
the landing gear mount for the U-shaped rigging mount installation.
14. Insert the rigging wires to the mounting tabs as shown. Insert the rigging mounting tabs inside the slot
on both sides and install the landing gear with supplied screws and lock everything in place at the same
time.
8
Advertisement
