Advertisement
S-2B
24. According to your marks use a knife to carve a slot and drill a hole for the U-shaped rod installation
as shown above.
25. Epoxy glue the U-shaped rod to the elevator halves and ensure the halves stay perfectly flat without
twisting whilst the glue sets. Then slide the elevator assembly into the fuselage tail section as shown.
26. Make sure the stabiliser is true and level to the fuselage and wings before you apply CA glue. Use
epoxy or CA glue to hinge the elevator to the stabiliser. Ensure free movement of the elevator when the
glue has set.
12
Advertisement
