Advertisement
21. Hardware for the tail assembly. Trial fit the stabiliser onto the fuselage tail section. Ensure the
stabiliser is true, square and level. Mark the area's which are going to be glued on the tail section and
remove the covering so that you are bonding wood with wood, not to the covering.
22. Please take note. When you use a knife to remove the covering on the stabilizer make sure you trim
just inside the marks you have made so that a small amount of covering is glued to the rear fuselage as
well. Otherwise you will see a thin strip of bare wood where the glue joint is.
23. Trim away the covering on the rudder carefully for the control horn and tail landing gear steering
horn. Center the supplied U-shaped linkage rod on the elevators and use a pen to mark where it is to fit.
11
Advertisement
