Table of Contents
Advertisement
TM
WebControl
PLC User Guide Version 3.02.17f
TM
3 WebControl
PLC Web GUI Configuration
TM
TM
To access WebControl
PLC, connect WebControl
to the local network and power
supply. The default IP address will be 192.168.1.15. Be aware that once you enable
DHCP in your WebControl network settings page, you will need to check your DHCP
server log for which IP address DHCP assigned to the board. You need to know and
understand the network you attaching this hardware to in order to know where to look
for DHCP server logs. For home networks, DHCP serving is commonly enabled at
TM
the router. Each WebControl
PLC board has a unique MAC address. Look in the
DHCP log to find the matching MAC address, then you can find the IP address
DHCP assigned to the hardware. From a computer connected to the same network,
start a web browser, and point to that IP address: for example:
http://ww.xx.yy.zz
when the web page loads, you will be prompt for login. The default user ID and
password is: "admin/password", all in lower case. You will see this page once
logged in:
TM
Figure 3.0 WebControl
PLC system status
3.1 Network Settings
TM
These are the basic settings that need to be configured in order for WebControl
to
work successfully on a network. It may be necessary to connect the board directly to
a PC and access it using its default IP address before connecting directly to a live
Copyright(c) 2008,-2013 CAI Networks, Inc.
5
Advertisement
Table of Contents
