I/O Setup; Figure 5.0 I/O Setup - CAI Networks WebControl PLC User Manual

3.2 I/O Setup

TM
WebControl PLC allows users to directly from browser control each output, or
through the PLC logic to control the TTL output. For flexibility, user can decide if the
TTL input or out to be inverted between logic 0 and logic 1. To use PLC logic, first
user must check the "Global PLC enable" to start the PLC engine. Then for each
TTL output, user can decide if the PLC control will be applicable.
TM
WebControl PLC allows user using browser to directly control the output state. If a
command line utility or third party control software used, you will need to enable the
Browser Control for that TTL output, also may need to go to network configuration to
disable the Web login (see figure 4.0).
The inverted state will be remembered in EEPROM even after power loss. The invert
state will be restored upon power resumed.
X10 Enable will allow user to send X10RF commands through TTL port7 and TTL
port8. Those two ports will not be able to perform any other function, once X10 is
enabled.
Copyright(c) 2008,-2013 CAI Networks, Inc.
TM
WebControl

Figure 5.0 I/O setup

PLC User Guide Version 3.02.17f
8