Settings - Balance Point - Lennox ComfortSense 3000 Series Operation Manual

MO TU WE TH FR SA SU
10:i2
AM
PM
PROG A B C D
ROOM
78
°
Figure 15. Reminders
After the filter has been changed or maintenance
performed, reset the reminder by pressing the SETTINGS
button for four seconds. The screen will blink for a few
moments to indicate that the timer has been reset.
Internal/Remote Sensor
If the optional Remote Indoor Sensor (10K) (47W37) is
connected and configured it will serve as a room
temperature sensor instead of using the internal
temperature sensor built into the thermostat. The dip switch
(position #4) is used to select either built-in or external
MAINT
FILTER
SERVICE
FAN
ON
AUTO
HOLD
SYSTEM
COOL
OFF
UC
HEAT
remote indoor temperature sensor used for temperature
control.
Occupied and Unoccupied Modes
During permanent hold mode the occupancy output follows
the program. During two hour hold mode the user can
change the occupancy status by pressing the enter button.
The occupancy status will be changed to occupied OC or
Unoccupied UC alternatively by pressing the enter button.
The occupancy relay is turned on when the user selected
the occupancy status during programming. The default
state of the occupancy relay is off. The occupancy relay will
turn on the economizer in the system
Table 2. Thermostat Outputs (Occupancy)
Demand Condition
Cooling Demands with Occupancy
First Stage Cooling
Second Stage Cooling
No Demand - Continuous mode
No Demand - Auto mode
Heating Demands with Occupancy
First Stage Heating
Second Stage heating
No Demand - Continuous mode
No Demand - Auto mode
Page 11
W1 W2 OC
X
X
X
X
X X
X X X
X
X
5/2 DAY PROGRAMMABLE COMMERICAL THERMOSTAT
Y1 Y2 G
X X
X X X
X
X
X
X
X