Malfunction Display And Solutions - ECOSTAR WM08-700 Owner's Instruction Manual

Malfunction Display and Solutions

When the washer is in trouble, please contact Authorized EcoStar Service Center. Customer should not
dismantle the machine without permission and warranty will be considered voided..
If the washer cannot work normally, and abnormal indication or error codes are shown on LED Digits dial
or machine will make buzzer alarm for warning. Please check the error codes and take corrective actions
as show below:
Error Message
Fault
Alarm for
water inlet
flares
Alarm for lid
opening
flares
Imbalance
alarm
flares
Drain alarm
flares
Overflow
alarm
flares
Note:
Please refer to EcoStar Washing Machine Warranty Card for complete address and phone
numbers of Authorized Service Center within your city
Indication
Water injection for about 16 minutes,
but do not reach the preset water
level
Ÿ
Open the lid after starting the delay
time.
Ÿ
Open the lid when Washer is
spinning.
Ÿ
Open the lid when entering into the
child lock state.
Checked imbalance of washing drum
for third time by the computer but
could not balance the spinning.
Alarm for water drain time out.
After the water reaching the preset
water level, water injection dosent
cease.
22
Alarm buzzing Stopping the
sound
alarm
The buzzer
goes on
buzzing for
Open the lid
10 seconds.
to deal with
If the fault is
faults, then
not solved,
close the lid
buzzes
to stop the
again for 10
alarm
seconds in
every 6
minutes